> > I have one more doubt.
> > In that thread, i have studied in the manual that the count 0 means the execution
>of one time.
> > count 1 means two times.
> > But in real senario its not exactly so.
> > For zero, it is not working.
> > if i set that count to 1 the test plan is executed for one time.
> > please clear me this one also.
>
> The documentation is incorrect in that spot. Thanks for pointing it out, I will fix
>it.
Hello,
I'm VERY new to JMeter and I was going to ask a similar question, but since
I found this message I would also like to point out something else.
>From my tests:
- 1 Interleave with 2 pages inside, if I set 1 Thread and 0 Loop counts it loads the
first
of the 2 HTTP Requests once;
- Same as above but Loop count set to 1, loads the first of the 2 HTTP Requests
once;
- Same as above, Loop Count =2, loads once each of the 2 pages.
Also, I noticed that it seems like it gets a little confused if you change a lot of
times
the number of loops and/or threads. Now I closed and restarted and don't show a
problem that I could see before, that is to say:"interleaves that were at the same
leverl didn't get run all the time, but just sometimes. More specifically the first
interleave was always executed, the second one only when I reaised the number of
Threads". After closing and restarting everything now seems to have been sorted
out.
I wouldn't know how to reproduce this any better because I worked and tested for a
few hours so I can't remember the complete sequence of things I did, except for
changing a lot of times the number of Loops and Threads. Oh, I was using the
Listener "View Results in Table". The tree view seems to work somehow better (to
me).
Thank you,
Andrea
--
To unsubscribe, e-mail: <mailto:[EMAIL PROTECTED]>
For additional commands, e-mail: <mailto:[EMAIL PROTECTED]>
