Also you can set Number of Treads = 0 if you want some thread group not to run. We use that for debugging.
> -----Original Message----- > From: Vladimir Tsygankov [mailto:[EMAIL PROTECTED] > Sent: Tuesday, May 03, 2005 2:40 PM > To: 'JMeter Users List'; 'Manjunath N.S.' > Subject: RE: Run|Start Command > > > Hello, > It is not a bug. I think you should separate your test script > in two scripts with one Thread group in each. > > Regards, > Vladimir > > > -----Original Message----- > > From: Manjunath N.S. [mailto:[EMAIL PROTECTED] > > Sent: Tuesday, May 03, 2005 11:56 AM > > To: JMeter Users List > > Subject: Run|Start Command > > > > > > Hi, > > > > I have two ThreadGroup and under each Thread Group i have > > test Cases. When I Select Thread Group1 and run the Test > > Case, I Expect ThreadGroup1 Test Cases to be run and results > > shown only for that, but with My JMeter version 2.0.3 it runs > > all the Test Cases under all of the Thread Group.. > > > > Is it bug? or there any work around ? > > > > thanks > > manju > > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [EMAIL PROTECTED] > > For additional commands, e-mail: [EMAIL PROTECTED] > > > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
