sorry. statusString is the name of the variable, getStatusDone is just the
label for the RegEx processor (you can see it in the screen capture).
Sorry for such a basic question but what type of listener can I use to write
to a file and tell how many loops each thread has done?
Thanks,
Matt
On 10/19/05, sebb <[EMAIL PROTECTED]> wrote:
>
> If you add a suitable Listener and write to a file, you can tell how
> many loops each thread has done.
>
> If the RE output is saved in "getStatusDone" then how does the
> variable "statusString" get set?
>
> S.
> On 19/10/05, Matt Edelman <[EMAIL PROTECTED]> wrote:
> > Hello,
> >
> > I'm writing a SOAP load test that has a while loop to check the status
> of a
> > process on the server under test. The SOAP response is parsed with a
> RegEx
> > post-processor looking for "<State>done". That value is then put into a
> > variable named getStatusDone. The while condition is as follows:
> >
> > ${__javaScript("${statusString}" != "<State>done",dummy)}
> >
> > If I run the test with one user, the while loop will run until it gets
> the
> > "done" response from the server.
> >
> > When I increase users to 5 users, 5 loops, I expect that once the test
> is
> > done running, the AUT SOAP log should show 25 "done" responses but it
> only
> > shows four. Is it possible that the very first "done" response from the
> > server is shutting down the while loop for all users? If so, what can I
> do
> > to avoid this?
> >
> > I have put a screenshot of the test at the following URL:
> > http://www.stupidcatchphrase.com/jm/
> >
> > Thanks,
> > Matt
> >
> >
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [EMAIL PROTECTED]
> For additional commands, e-mail: [EMAIL PROTECTED]
>
>
