Thanks for the reply. How do you know that the messages are on the queue? - I use a tool called RFHUtil from IBM to lookup the queue.
Can you read them with a different application? - I use a tool called RFHUtil from IBM to lookup the queue. Can you read any JMS messages with JMeter? -Not sure what sampler to use to perform this other than what I did, JMS Point-to-Point Request-Response. I thought my post was at dead bottom so I gave it one more try. Sorry for the redundant post..... What would be the next step if no "user" can help me out here.....Is there a way for a new user like me to open a bug? Not sure... Thanks Sai On Nov 13, 2007 10:22 AM, sebb <[EMAIL PROTECTED]> wrote: > Sorry if there has been no reply; I assume no-one with experience of > JMS is reading this. > > That includes me ;-) Not knowing JMS, these suggestions may be useless: > > How do you know that the messages are on the queue? > Can you read them with a different application? > > Can you read any JMS messages with JMeter? > > Just something to try. > > > On 13/11/2007, Sai Padimiti <[EMAIL PROTECTED]> wrote: > > Hi: > > > > I have configured a JMS Point-to-Point sampler with communication > > style Request Response using JNDI settings. > > > > JMeter was successfully putting the message into the Request Queue but > > not able to get the message from Receive Queue. It is failing with an > > error as below: > > ------ > > 2007/11/08 17:21:55 INFO - > > jmeter.protocol.jms.sampler.Receiver:Receiver - ctor. Connection to > > messaging system established > > 2007/11/08 17:22:00 INFO - > > jmeter.protocol.jms.sampler.MessageAdmin:Message with > > ID:414d5120574d425f514d202020202020ca742f4720077e02 not found. > > ----- > > > > This situation repeats irrespective of the value of Timeout parameter. > > I tried from 1000 (ms) to 10000(ms). Pretty sure that the response > > message is getting placed in Response Queue with in the Timeout parameter. > > > > Also made sure that the response message contains the same message ID > > as JMeter is setting it to the request message. > > > > What could be the problem and is there any JMS property that needs to be > > set? > > > > Please provide some help.... > > > > Thanks > > Sai > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [EMAIL PROTECTED] > > For additional commands, e-mail: [EMAIL PROTECTED] > > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
