Hi, if you want to make a test plan which should send out independent requests, one every 5 seconds, set up your thread group as following:
Thread Group --- Your Request here And the Thread Groups options should be set to Number of threads(users) = Number of requests to send out (lets call it NREQ) --- e.g. 100 Ramp up period(in seconds) = 5*NREQ --- e.g. 500 Loop Count = 1 Then in you test plan, every 5 seconds a new thread will be spawned, will immediately open its own connection, send out the request, get the response and die. The time between the requests will be very close to 5 seconds. Regards, Andrey On Fri, Aug 29, 2008 at 3:14 PM, Jeremy Quinton <[EMAIL PROTECTED]> wrote: > > I have adjusted the ramp up time it does not seem accurate. > I have also been through the documentation "building a web test plan". > > I created another simple test with the following values. > > Number of threads(users) 1 > Ramp up period(in seconds) 10 > Loop Count 1 > > Below the thread group I have two http requests. > If I run the test and view the results in table format > the start time of the requests is 3 and then 2.6 seconds apart. > > What I want to achieve is measure throughput so 1 request every 5 > seconds. Then at a later stage 1 request every 4 seconds etc. > > This is sample data when I view results in a table format. > > Sample 1 > 19 12:03:15.457 > 20 12:03:18.399 > Sample 2 > 21 12:09:37.167 > 22 12:09:39.854 > > Thanks for yor help in advance. > > Are there any other tools you could suggest I use that are > free/opensource > and similar to jmeter but have this functionality. Ive spent three days > Days on this tryig different combinations and values and still no luck. > > > > -----Original Message----- > From: Ronan Klyne [mailto:[EMAIL PROTECTED] > Sent: 29 August 2008 11:35 > To: JMeter Users List > Subject: Re: simultaneous http requests > > Jeremy Quinton wrote: >> Hi >> >> >> >> I have setup a basic test to apply some load to a server. >> >> I have one thread group with multiple http requests. >> >> >> >> Viewing the results of the test in a table it looks like jmeter >> >> does a http request waits for it to finish and then does the next >> request. >> >> >> >> What I would like to do is >> >> >> >> Send an http request >> >> Wait 5 seconds (Used a constant timer) >> >> Send another request >> >> Wait 5 seconds.(Used a constant timer) >> > > The option you're looking for is 'Ramp up time' on the Thread Group. > >> The problem is that the second request will only start after the first >> request has completed >> >> + the delay of 5 seconds. >> >> >> >> Is this possible? Also is there anyway of searching the archives. > There >> is no search option >> >> and so I have to manual go through each question to see if my question >> has been asked >> >> >> >> Thanks >> >> Jeremy Quinton >> >> >> >> > > > -- > Ronan Klyne > Business Collaborator Developer > Tel: +44 01189 028518 > [EMAIL PROTECTED] > www.groupbc.com > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > -- diem perdidi --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
