I think you can use "CSV Data Set Config" or "user Parameters" to accomplish the below task.
With Regards, Suvendu -----Original Message----- From: jmeter-user [mailto:[email protected]] Sent: Thursday, May 28, 2009 12:10 PM To: [email protected] Subject: read data from file ( in loop ) and put into Variables Hello I need read data from file user.txt ( in loop ) and put into Variables: FILE : http://www.nabble.com/file/p23756075/jmeter2.jpg USER PARAMETRES - what i should change in this section ??? I need read data in one loop from first line , next loop from next line and put into variables First line : 48668375729 Next line : 12312312331 .... http://www.nabble.com/file/p23756075/jmeter1.jpg -- View this message in context: http://www.nabble.com/read-data-from-file-%28-in-loop-%29-and-put-into-Variables-tp23756075p23756075.html Sent from the JMeter - User mailing list archive at Nabble.com. --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] DISCLAIMER: This email (including any attachments) is intended for the sole use of the intended recipient/s and may contain material that is CONFIDENTIAL AND PRIVATE COMPANY INFORMATION. Any review or reliance by others or copying or distribution or forwarding of any or all of the contents in this message is STRICTLY PROHIBITED. If you are not the intended recipient, please contact the sender by email and delete all copies; your cooperation in this regard is appreciated. --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
