All,

 

I have created 5 thread groups(TG) for different scenarios. I would like
to run them in following manner:

 

1.       Every time, run Thread Group1

2.       For every even times, run TG4 & TG5

3.       For every third time, run TG2, TG3 & TG5

 

I would like to create a Loop controller on top of all Thread Groups...
What changes, should I do to achieve above scenarios?  

 

 

Thanks & Regards,

Palani Selvam

 




*******************************************************************************************************

This E-mail message and its attachments, if any are intended solely for the use 
of the addressee hereof. In addition, this message and the attachments, if any 
may contain information that is confidential, privileged and exempt from 
disclosure under applicable law. If you are not the intended recipient of this 
message, you are prohibited from reading, disclosing, reproducing, 
distributing, disseminating or otherwise using this transmission. 


Delivery of this message to any person other than the intended recipient is not 
intended to waive any right or privilege. If you have received this message in 
error, please promptly notify the sender by reply E-mail and immediately delete 
this message from your system.  Instructions transmitted over this system are 
not binding on us until they are confirmed by us. Message transmission is not 
guaranteed to be secure or free of software virus. While Altisource Portfolio 
Solutions and its subsidiaries collectively "Altisource" takes every reasonable 
precaution to minimize such risks, Altisource cannot accept liability for any 
damage sustained by you or any third party as a result of software viruses.

*******************************************************************************************************

Reply via email to