There's no reason this should be so difficult. Jmol 11.7.47 introduces:
# new feature: draw ARC {center} {plane}
# new feature: draw ARC {center} {axisPoint}
# new feature: draw CIRCLE {center} {plane}
# new feature: draw CIRCLE {center} {axisPoint}
The difference between ARC and CIRCLE is that ARC with just these two
parameters creates a ring that can be used to "finish off" a CIRCLE, which
is basically a flat plane. A thin ring can also be made using CIRCLE and the
display keywords MESH NOFILL
Bob
On Sun, Jul 5, 2009 at 4:35 PM, Robert Hanson <[email protected]> wrote:
> That page uses the
>
> draw CYLINDER {pt1} {pt2} diameter 3.0
>
> command, with the two points just slightly offset so that it is a very
> short cylinder
>
> 2009/7/5 Angel Herráez <[email protected]>
>
> Sorry, "draw circle" is not what you need, I forgot about that. It's "draw
>> arc"
>>
>>
>>
>> ------------------------------------------------------------------------------
>> _______________________________________________
>> Jmol-users mailing list
>> [email protected]
>> https://lists.sourceforge.net/lists/listinfo/jmol-users
>>
>
>
>
> --
> Robert M. Hanson
> Professor of Chemistry
> St. Olaf College
> 1520 St. Olaf Ave.
> Northfield, MN 55057
> http://www.stolaf.edu/people/hansonr
> phone: 507-786-3107
>
>
> If nature does not answer first what we want,
> it is better to take what answer we get.
>
> -- Josiah Willard Gibbs, Lecture XXX, Monday, February 5, 1900
>
--
Robert M. Hanson
Professor of Chemistry
St. Olaf College
1520 St. Olaf Ave.
Northfield, MN 55057
http://www.stolaf.edu/people/hansonr
phone: 507-786-3107
If nature does not answer first what we want,
it is better to take what answer we get.
-- Josiah Willard Gibbs, Lecture XXX, Monday, February 5, 1900
------------------------------------------------------------------------------
_______________________________________________
Jmol-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/jmol-users
