Dear all,
For the execution of a remote command to retrieve the power consumption of certain devices on certain ports of an HP ProCurve 2600 switch, we were investigating the usage of JSCH, more specifically the exec example from the jsch distribution. However, we seem to bump into an issue using this approach, because the switch returns some kind of welcome screen. See below for an example. Therefore, the command is not executed remotely. At least we think, because we cannot receive any output. Has any of you been successful in such a use case, of has any examples or references available towards the correct JSCH usage? Thanks! Cheers, Stijn ProCurve J8164A Switch 2626-PWR Software revision H.10.38 Copyright (C) 1991-2007 Hewlett-Packard Co. All Rights Reserved. Press any key to continue -- Stijn Verstichel - PhD Researcher Department of Information Technology Broadband Communication Networks (IBCN) Ghent University - IBBT Gaston Crommenlaan 8 (Bus 201), B-9050 Gent, Belgium T: +32 9 33 14940 ; T Secr: +32 9 33 14900 F: +32 9 33 14899 E: [email protected] W: <http://www.ibcn.intec.ugent.be/> www.ibcn.intec.UGent.be W: www.ibbt.be
------------------------------------------------------------------------------ This SF.net email is sponsored by Make an app they can't live without Enter the BlackBerry Developer Challenge http://p.sf.net/sfu/RIM-dev2dev
_______________________________________________ JSch-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/jsch-users
