Uwe, For Project saving to work a layer must have a DataStoreQuery set, this is probably not the case for the image layers.
Paul Uwe Dalluege wrote: > Hi, > > > I try to save a Project with an Image file > but it does not work: > > > 1. File>Open>Geographically Registered Tagged Image File Format > 2. The image is visible. > 3. File>Save Project AS... > 4. An error appears: Some layers were not saved to the project file:... > > > Regards > > Uwe > > ------------------------------------------------------------------------- > SF.Net email is sponsored by: > Check out the new SourceForge.net Marketplace. > It's the best place to buy or sell services > for just about anything Open Source. > http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace > _______________________________________________ > Jump-pilot-devel mailing list > Jump-pilot-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/jump-pilot-devel > ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Jump-pilot-devel mailing list Jump-pilot-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/jump-pilot-devel