Yes Jacob is right...TCC encapsulation is used when you have interworking scenario like any to any (but dis-like).
I have another issue in L2VPN kompella, while reading documentation from Juniper Website, i find there are options like multihoming and active-Interface but this is not present in actual. I have Juniper J4300 with JunOS 8.2 but this options are hidden...! http://www.juniper.net/techpubs/software/junos/junos82/junos-xml-ref82-config/html/summary-s226.html <configuration> <logical-routers> <routing-instances> <instance> <protocols> <l2vpn> *<site> * <name>*name* </name> <!-- identifier --> <site-identifier>*site-identifier*</site-identifier> <!-- mandatory --> <multi-homing/> <site-preference>*site-preference-choice* </site-preference> <active-interface> *...*</active-interface> <interface>*...*</interface> * </site> * </l2vpn> </protocols> </instance> </routing-instances> </logical-routers> </configuration> I want to implement a scenario where CE1 is connected to PE1 via two lastmiles (1st primary and another Secondary). CE2 is connected to PE2 via only single lastmile. If i have to provide CE1 with backup facility (as protected-interface in Martini), I have only site-preference parameter, which not provide enough control. It provide backup facility in a scenario when both L2VPN instances have atleast two two interfaces (one primary and another secondary) and then create SiteA on Interface 1 with preference High and create SiteB on Interface2 with preference Low. If any one have gone through these type of implementations than please share there solutions and comments. Regards Fahad Ali Khan On 2/8/07, Muhammad Teguh Pribadi <[EMAIL PROTECTED]> wrote: > Hi, > > I think Jacob is right; the problem arose because you had used tcc encap. > You can see my attached files. Hope it useful for you. > > Regards, > Muhammad Teguh Pribadi > > > > "Bourgeois, Jacob (Jake)** CTR **" <[EMAIL PROTECTED]> wrote: > Hi, > > Your use of tcc encaps on the interfaces is probably the issue. Since > you've told l2vpn that your encaps is for vlan, you should be using > vlan-ccc > for interface encaps. TCC is usually used for FR to ATM, ATM to Eth, etc. > I could be wrong here but give it a shot. > > LDP vs RSVP tunnels. L2vpn is kompella, so mp-bgp is setting up parameters > > on control plane, should just use any tunnel as long as there is an entry > in > inet.3 for the remote pe router-id, regardless of signaling used. > > HTHs > > Jake Bourgeois > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Telmo Javier Di > Leva > Sent: Wednesday, February 07, 2007 2:32 PM > To: [email protected] > Subject: [j-nsp] L2VPN config sample! > > ....................................................................... > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
