----- Original Message ----- From: "Gökhan Gümüº" <[EMAIL PROTECTED]> [...] > I have two links between these M10i and M7i and i want to > bundle these two link to a one multilink interface.Problem > is one side of my link is configured with encapsulation > frame-relay and one side of link is terminated on my ATM > card. > > Is there way to configure these two links as a one > multilink interface?
I can imagine possibilities. If the links are run through a switch which is performing FRF.8 frame-ATM interworking, it may be possible to run PPP on top of the frame and ATM (I believe I set it up at one point on Cisco equipment, some years back), but it's a pretty obscure config, and it's generally easier to bundle the links in the switch (FRF.16 MFR -> single ATM PVC, as I'm assuming multiple smaller links on the serial side to a larger ATM interface, you said "ATM card" and not "cards", and "IMA" and "Juniper" don't mix). And then there's always ECMP. Peter E. Fry _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
