check out clause 37 in auto-negotiation IEEE802 standard, you will need to explicitly set the speed and duplex settings. Auto-negotiation works for cisco to cisco and on occasions to HP procufve, far too often the auto-negotiation fails with other vendors. Clause 37 says vendors develop their own auto-negotiation , a cop out I know.
Go for lowest denominator and configure up until you achieve the speed duplex you require Sabri Berisha <[EMAIL PROTECTED]> wrote: On Tue, Oct 16, 2007 at 10:51:22PM +0900, usacox wrote: Hi, > Thank you for your reply. > > I configured same setting both interfaces with auto-negotiation. > > I am looking with no-autonegotiation configuration without its fellow > after this problem. Some devices implicitly disable auto-negotiation when you explicitly configure speed and duplex settings. For J-series interfaces, the Fast Ethernet PIMs automatically disable auto-negotiation if you configure both speed and duplex settings. The Gigabit Ethernet PIMs do not, if you want to disable auto-negotiation on GE you will have to do so under gigether-options. If you have a link where one end is doing auto-negotiation and the other is not, you will end up with the first end (the one doing auto-neg) in half-duplex. This is the specified default according to 802.3u. Thanks, -- Sabri _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
