On Tue, Jun 03, 2008 at 12:52:23PM -0400, Brendan Mannella wrote: > Hello, i have a M7i with a FE-4FE-TX, and i am seeing collisions on > the interfaces. I am using two ports of the four, and both are > showing the errors. I am also seeing some FIFO errors. Are these > signs of a faulty PIC or should i not be concerned? Thoughts?
Collisions are normal for half-duplex Ethernet. These interfaces are autonegotiating to 100mbps, half-duplex: > Physical interface: fe-0/3/0, Enabled, Physical link is Up > Link-level type: Ethernet, MTU: 1514, Speed: 100mbps, Loopback: Disabled, > Source filtering: Disabled, Flow control: Enabled > Carrier transitions: 0, Errors: 0, Drops: 0, Collisions: 138037, Aged > packets: 0, FIFO errors: 0, HS link CRC errors: 0, MTU errors: 0, > FIFO errors 0 212 > Autonegotiation information: > Negotiation status: Complete > Link partner: > Link mode: Half-duplex, Flow control: None, Remote fault: OK > > Physical interface: fe-0/3/1, Enabled, Physical link is Up > Link-level type: Ethernet, MTU: 1514, Speed: 100mbps, Loopback: Disabled, > Source filtering: Disabled, Flow control: Enabled > Carrier transitions: 0, Errors: 0, Drops: 0, Collisions: 66445, Aged > packets: 0, FIFO errors: 0, HS link CRC errors: 0, MTU errors: 0, > FIFO errors 0 118 > Autonegotiation information: > Negotiation status: Complete > Link partner: > Link mode: Half-duplex, Flow control: None, Remote fault: OK _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
