Hi there, Have a look at "psn-tunnel-endpoint" knob http://www.juniper.net/techpubs/software/junos/junos91/swconfig-vpns/configuring-layer-2-circuits-over-both-rsvp-and-ldp-lsps.html#id-12217017 This knob is useful if you configure 2 RSVP LSP terminating at different [EMAIL PROTECTED] the egress LSR. Or use two additional "no-install-to" and "install <prefix/mask>" knobs to make sure your ingress LSR inet.3 table contains two different/distinct prefixes belonging to egress LSR. Rgds Alex
2008/7/7 Junaid <[EMAIL PROTECTED]>: > Hi, > > Is there a way to map Martini tunnel traffic onto a specific LSP. I > have a few Martini tunnels created between two M-series routers that > are connected via redundant WAN links. In order to load balance/share > Martini traffic onto these links, I was thinking of somehow manually > mapping the tunnels onto RSPV configured LSPs between the two routers. > Each LSP follows a different WAN link. I have created the LSP and > verfied that it follows the desired path. Now how can I bind the > traffic of one Martini tunnel with one LSP or any similar solution to > achieve load-balancing/sharing of Martini tunnel traffic over multiple > links. > > > Regards, > > Junaid > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
