Steinar,
Do you have any decent refs or axamples for getting started with L2circuit?
ie we have an existing pure L3 set up, what do we need to do to add L2
fuctionality across multiple sites?
Thanks
[EMAIL PROTECTED] wrote:
I have to jump in, since I am also interested :-)
My question is, what do you think the cost/benefit of L2VPN over VPLS?
It seems that L2VPN is restricted to point-to-point and there is a
separate vrf (and a routing table) for each link, while VPLS maintains
a single vrf and routing table. Have you guys thought about using
VPLS? Or is there any problems with it? Maybe scalability?
Can't really comment the (Juniper proprietary) L2VPN. However, we use
both Martini tunnels (L2circuit in Juniper terminology) and VPLS. The
two technologies are quite different:
- L2circuit (and L2VPN) give you a point-to-point link. You can think
about the technology as a pipe where packets are inserted at one end
and come out at the other end. No MAC address learning is necessary.
Troubleshooting is fairly simple (no need to go looking for specific MAC
addresses and where they originate). Scaling is fairly good - we have
M7i routers with more than 2000 L2circuits. You need to watch your FEB
memory utilization, though.
- VPLS give you a layer 2 multipoint network - in effect you are making
your network look like a large LAN. MAC address learning is necessary,
and only the MX boxes are able to do this in hardware. Replication of
broadcast/multicast/unknown unicast traffic is at the *source*, which
has the potential to melt down your network (e.g. one 100 Mbps stream
replicated to 20 different PE routers gives you 2 Gbps of traffic from
your ingress router towards your network core). Both the technology
and the troubleshooting is significantly more complex than L2circuit/
L2VPN.
I don't want to give the impression that VPLS is all gloom and doom.
Juniper has done a reasonable job of making the technology stable,
especially in later JunOS versions, and P2MP LSPs help significantly
with the ingress replication problem. However, L2 point-to-point is
still a significantly simpler technology no matter how you look at it.
Steinar Haug, Nethelp consulting, [EMAIL PROTECTED]
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
--
This email and any files transmitted with it are confidential and intended
solely for the use of the individual or entity to whom they are addressed.
If you have received this email in error please notify the sender. Any
offers or quotation of service are subject to formal specification.
Errors and omissions excepted. Please note that any views or opinions
presented in this email are solely those of the author and do not
necessarily represent those of Lumison and nPlusOne.
Finally, the recipient should check this email and any attachments for the
presence of viruses. Lumison and nPlusOne accept no liability for any
damage caused by any virus transmitted by this email.
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
