Hi,

"The domain ID
allows the receiving PE router to advertise routes as either Type 3 or
Type 5 LSAs." JNCIS Study Guide, P-631.

i.e. it is used locally by the PE and compared against the Domain ID
value received in the MBGP advertisements. The Domain ID attribute
received in the MBGP advertisements is set by other PE(s) via the
domain-id community using an export policy.

As far as the second question is concerned, i hope the following link
answers it:
http://jnpr.net/techpubs/software/junos/junos55/swconfig55-vpns/html/vpnl3-config19.html


Regards,
Junaid



On Fri, Dec 26, 2008 at 12:37 PM, Ahmad Alhady <[email protected]> wrote:
>
> in case of using OSPF as PE-CE routing protocol .. ..
>
> why
> we should assign the domain-id community to the exported routes? ?? I
> think that specifying domain-id under the protocols ospf  hierarchy is
> enough to send the domain-id on the route... ? ?! ! !
>
> another point . . .
> when we use "vrf-table-label" ? ! !
>
>
> Thanks
>
> Ahmad
>
>
>
>
> _______________________________________________
> juniper-nsp mailing list [email protected]
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp

Reply via email to