Hi Michael,
Perhaps you may want to use the jnxBoxAnatomy MIB:
show snmp mib walk jnxBoxAnatomy
jnxBoxClass.0 = jnxProductLineM10i.0
jnxBoxDescr.0 = Juniper M10i Internet Backbone Router
jnxBoxSerialNo.0 = 30014
[snip]
jnxContentsSerialNo.2.1.0.0 = S/N PJ12468
jnxContentsSerialNo.2.1.1.0 = S/N PJ12468
jnxContentsSerialNo.2.2.0.0 = S/N PJ12808
jnxContentsSerialNo.2.2.1.0 = S/N PJ12808
jnxContentsSerialNo.2.3.0.0 = S/N PJ12464
jnxContentsSerialNo.2.3.1.0 = S/N PJ12464
[snip]
Cheers,
Truman Boyes
On 18/03/2009, at 1:27 AM, Michael Skulsky wrote:
Hi,
I was planning to use some fields from RFC2737 (ENTITY-MIB) for my
monitoring application; in particular entPhysicalSerialNum and
entPhysicalMfgName. To my surprise the mx960 router does not seem
to have this MIB, documentation says that it is supported on E-
series routers only. Could you advice what MIB I should use instead?
thanks
Michael
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
