hey try
#show services stateful-firewall flows cheers Ivan On Fri, Oct 23, 2009 at 8:04 PM, <[email protected]> wrote: > Hi, > > > > I have configured an SRX machine with source NAT and destination NAT as > followed: > > set security nat source pool WAN_Address address x.x.x.x/32 > > set security nat source rule-set interface-nat from zone trust > > set security nat source rule-set interface-nat to zone untrust > > set security nat source rule-set interface-nat rule rule1 match > source-address 10.0.0.0/24 > > set security nat source rule-set interface-nat rule rule1 match > destination-address 0.0.0.0/0 > > set security nat source rule-set interface-nat rule rule1 then source-nat > pool WAN_Address > > set security nat destination pool Int_Servers address 10.0.0.4/32 > > set security nat destination rule-set rule1 from interface fe-0/0/2.0 > > set security nat destination rule-set rule1 rule NAT-to-Server match > destination-address x.x.x.x/32 > > set security nat destination rule-set rule1 rule NAT-to-Server then > destination-nat pool Int_Servers > > set security nat proxy-arp interface fe-0/0/2.0 address x.x.x.x/32 > > > > [x.x.x.x is my WAN IP Address on fe-0/0/2] > > > > How can I verify that this config is working from within the SRX? > > While trying to ping some outside address with source ip of my internal LAN > interface (10.0.0.254) I'm not getting back any answer > > > > Best Regards, > > MTC > > > > > > > > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
