-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hello all, I'm attempting to find documentation on this, but have been unable to. Is it possible to clear all the arp entries from a layer 3 logical interface on an M/MX series router? The interface is a trunk doing vlan tagging, and has multiple logical interfaces off the single physical interface. There were a couple ways to do this on Cisco depending on the device and IOS revision. Some devices you could do a "clear arp interface" on the vlan, while others you could set a very low "arp timeout" temporarily on the subinterface. I attempted to look for the latter equiv on Juniper, and found: http://www.juniper.net/techpubs/en_US/junos10.0/topics/task/configuration/arp-learning-aging-options-configuring.html
But from what I can tell, this only reduces the timer for *new* arp entries, not ones already in the arp table. Perhaps even a way to clear all the arp entries for a CIDR, as this would still speed the time instead of having to clear all the arp entries individually with "clear arp hostname x.x.x.x". Does anyone have any insight? Many thanks, /toph -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.9 (GNU/Linux) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org iEYEARECAAYFAktlZFIACgkQg4DtNh1wGhoc8gCgzyNV7d8fvKnAWcx5AXAOXXVg 3MQAoN/C+jRM4lQD7fmp/TaBfXGj8r62 =zG64 -----END PGP SIGNATURE----- _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
