Is there a document that can explain the attached code block for us? In
case the screen shot isn't clear, I am basically just sending a single-shot
of traffic (the packets are sent over 1 second) with, or without, a baseline
constant traffic which is below the policed rate.
Questions I have are:
Does "bandwidth-limit" include Inter-frame Gap? Does it include L2 header?
What does the "burst-size-limit" (MBS) actually do because looking at my
attached gif it doesn't seem to have any effect on bursts. No matter what I
set the MBS to I lose packets (not shown but the results are identical for
100g MBS as the rest of the lines in the file).
firewall {
policer 1 {
if-exceeding {
bandwidth-limit 10m;
burst-size-limit 3932160;
}
then discard;
}
}
interfaces {
ge-4/1/1 {
vlan-tagging;
encapsulation extended-vlan-vpls;
unit 1 {
vlan-id 1;
family vpls {
policer {
output 1;
}
}
}
}
}
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
