David Coulson wrote:
I have what I thought was a pretty simple config - Two VLANs on two GigE
interfaces, on a MX240 running 9.4R2.9 which are cross-connected within
the MX using a l2circuit.
If I remove the 'vlan-ccc' encap from the units and assign an IP, we can
ping to something on the other end - So at least we know end-to-end
works on both interfaces. Once it's reassembled as a l2circuit, there is
no connectivity between the two end points. I'm sure it's something
pretty elementary, but I can't determine what it is. Is there a way to
sniff or capture traffic on the l2circuit to see what is going on?
The VLAN numbers at both ends of the l2circuit need to be the same for
it to work.
This is a very poorly documented limitation of the l2circuit feature.
--
Regards
Andy Harding
Internet Connections Ltd
Phone: 020 7531 5655
Mobile: 07813 975 459
Fax: 01538 382596
Web: www.inetc.co.uk
Email: [email protected]
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
