What is the answer? :) ------Original Message------ From: Paul Stewart Sender: [email protected] To: [email protected] Subject: [j-nsp] BPDU Question Sent: Mar 23, 2010 10:21 AM
Hi folks .. thanks to those who replied offline to my last question (speed/duplex) - the answer was sitting right in front of me the whole time lol I have a new problem ... with our EX4200's we face many customer switches and I need to filter BPDU's out. In the Cisco world we would setup a port just like this: interface GigabitEthernet3/2 description xxxxxxxxxxx switchport switchport access vlan 66 switchport mode access switchport nonegotiate no ip address no cdp enable no mop enabled spanning-tree bpdufilter enable What is the equivalent to this in Juniper? I tried setting up "bpdu protect" one some interfaces but when it does see a BPDU packet it shuts the port down - we can't have that occur ... we just want to filter out BPDU's... Thanks ;) Paul _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp Sent via BlackBerry by AT&T _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
