Personally, I would halt the third member ("request system halt member 3"),
then pull the cables, and then change the VC configuration. But, that is
just my preferred way of doing it.
-Jon
On Tue, Mar 30, 2010 at 10:49 AM, Kevin Wormington <[email protected]> wrote:
> I'm running a production stack of 3 EX-4200s using the stacking ports on
> 9.6R1.3. I would like to remove the 3rd member (no ports in use or
> configured) which is just in line-card mode without effecting the other two.
> The units were all pre-provisioned. I'm curious if anyone has attempted
> this and if they just pulled the stacking cables first and then made
> software changes or made software changes and then pulled the cables?
>
> Thanks,
>
> Kevin
> _______________________________________________
> juniper-nsp mailing list [email protected]
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
