Configure the other ports - even if it's just setting them to "family Ethernet-switching" for now ... this will cause them to show up and be part of the configuration....
Paul -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Olof Kasselstrand Sent: May-31-10 6:53 PM To: juniper-nsp Subject: [j-nsp] EX4200 24 SFP ports not showing Hi, I have a EX4200 24 SFPs switch. When I try show interface terse only the port with SFP is shown. If I do a show inter ge-0/0/7 I get device not found if there is no SFP plugged in. Is it possible to change this? This is causing me trouble when I want to setup graphs for this switch. The interfaces don't show up in SNMP either. It would be nice to add all ports and as soon as I start using one port I'll get the graphs. Thanks, Olof _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
