The memory utilization in "Show chassis routing-engine" is misleading. Run a "Show system process extensive" look to see how much is free, Inact and Buf.(I think) Juniper has KB on this too.
Sample from M10: Mem: 448M Active, 110M Inact, 117M Wired, 38M Cache, 69M Buf, 27M Free Jensen Tyler Network Engineer Fiberutilities Group, LLC -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Tomas Lynch Sent: Wednesday, June 23, 2010 8:11 AM To: [email protected] Subject: [j-nsp] High Memory Utilization on J2350 I'm doing some RPM tests using two J2350 [1], both are connected to an M10. Before any RPM configuration (or even any configuration or any packet forwarding) the memory utilization of the router was around 86% of 512 MB. I'm blaming this on the stateful firewall that is preconfigured but I cannot find any evidence/document/ etc. to support this. I have even deactivated the screen config and put all the interfaces on the trust zone but the memory utilization stays at the same level. Is there anything I can do to reduce the memory utilization? I really don't need the firewall feature. Any help will be useful. Thanks, Tomas L. [1] Before somebody recommends using another router, let me explain: I didn't choose that particular router; it was bought before I was hired but now is my problem ;) _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
