Equipment: 1 Juniper M20 running JunOS 7.5R1.12 2 Cisco 2611 running 12.4.23 IOS Multiple T1 connections between the above devices
Background: I have read the following literature. http://www.juniper.net/techpubs/software/junos/junos56/swconfig56-interfaces/html/interfaces-multilink-config25.html and I have downloaded all the PDFs available on the documentation site and read all the sections that talk about setting up MLFR Goal: I need to setup MLFR between the two devices listed above. At this point, I am simply trying to get the Juniper side configured so I can see the interfaces involved. What I have done so far: Here is an example config from the Juniper [edit] j...@x# show chassis fpc 1 pic 2 mlfr-uni-nni-bundles 5; [edit] j...@x# show interfaces ls-1/2/0:0 description "Test MLFR interface"; dce; encapsulation multilink-frame-relay-uni-nni; unit 16 { dlci 16; family inet { address 66.39.177.129/32 { destination 66.39.177.130; } } } unit 17 { dlci 17; family inet { address 10.100.100.1/32 { destination 10.100.100.2; } } } [edit] j...@x# show interfaces t1-1/1/0:0 description "Test MLFR leg (1/2)"; encapsulation multilink-frame-relay-uni-nni; unit 0 { family mlfr-uni-nni { bundle ls-1/2/0:0; } } [edit] j...@x# show interfaces t1-1/0/0:19 description "Test MLFR leg (2/2)"; encapsulation multilink-frame-relay-uni-nni; unit 0 { family mlfr-uni-nni { bundle ls-1/2/0:0; } } After issuing "commit" the first thing I notice when I exit edit mode is that I cannot see the device ls-1/2/0:0. Question: At this point, should I be able to see the status of the device? Even if nothing is connected I am guessing, just like other interfaces that are configured, I should be able to see the status of that interface. Also, I have seen two example of doing this. The first involving the ls-x/x/x:0 interface and the other using lsq-x/x/x:0. I have tried both. Didn't change anything. Any help would be great! TIA -- Jim Lucas A: Maybe because some people are too annoyed by top-posting. Q: Why do I not get an answer to my question(s)? A: Because it messes up the order in which people normally read text. Q: Why is top-posting such a bad thing? _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
