Hi Amos, Could you please check the pool election process at: http://www.juniper.net/techpubs/en_US/junose11.1/information-products/to pic-collections/broadband-access/dhcpv6_local_addr_pools_ovrvw.html#dhcp v6_local_addr_pools_ovrvw I'd recommend to either set the pool name in the domain-map or provide the pool name by radius. I always use RADIUS to provide address/prefixes, but may remember that the IPv6CP fails when no pool is explicitly assigned and RADIUS does not provide prefixes.
Gruss Bernd -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Amos Rosenboim Sent: Wednesday, September 15, 2010 9:42 PM To: [email protected] Subject: [j-nsp] ERX310 IPv6 local pools Hello, I would like to enable IPv6 for subscribers connecting (PPPoL2TP) to our ERX310 (running 10.1.1). I decided to use IPv6 local pool, the pool is configured and enabled service dhcpv6-local. What do I need to configure so the router will start assigning IPv6 prefixes to the subscribers? I was able to assign IPv6 prefixes through Radius attributes, but I really prefer the local pool/dhcp option. Regards Amos _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
