Help me with my JUNOS commands structure and interfaces but unit 0 is the physical interface correct? I mean, you always have to configure unit 0 so to me that is just part of the interface configuration.
On Wed, Oct 13, 2010 at 8:36 AM, Bit Gossip <[email protected]> wrote: > This is Mx480 Junos10.2R2.11 and DPC. > Any idea why I can not apply a physical-interface-policer to a > physical-interface? > While it can be applied to 'unit 0' of the same interface. > > Thanks, > bit. > > [edit interfaces xe-4/1/0] > l...@rc2# run show configuration firewall policer L-ECN > physical-interface-policer; > if-exceeding { > bandwidth-percent 90; > burst-size-limit 64k; > } > then loss-priority high; > > [edit interfaces xe-4/1/0] > > l...@rc2# set layer2-policer ? > Possible completions: > + apply-groups Groups from which to inherit configuration data > + apply-groups-except Don't inherit configuration data from these > groups > > [edit interfaces xe-4/1/0] > l...@rc2# set unit 0 layer2-policer ? > Possible completions: > + apply-groups Groups from which to inherit configuration data > + apply-groups-except Don't inherit configuration data from these > groups > input-policer Two-color policer for received packets > input-three-color Color-blind three-color policer for received > packets > output-policer Two-color policer for transmitted packets > output-three-color Three-color policer for transmitted packets > > > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
