Hi,
I just figured it out.... The arp entry is created for the LSI interface or the local ports participating in a bridging or vpls instance. And not the BVI interface. Quite counter intuitive in my opinion..... Kind regards, Peter Krupl > -----Original Message----- > From: Hentati, Akram [mailto:[email protected]] > Sent: 06. May, 2011 16:10 > To: Peter Krupl > Subject: RE: Arp entries not showing on IRB interfaces. > > Hi Peter, > > Which command are u using? > > Cheers, > Akram > > > > > -----Original Message----- > From: [email protected] [mailto:juniper-nsp- > [email protected]] On Behalf Of Peter Krupl > Sent: 06 May 2011 11:23 > To: 'juniper-nsp List' > Subject: [j-nsp] Arp entries not showing on IRB interfaces. > > Hi, > > I could not find anything obvious in the KB. But it seems like IRB interfaces > arp > entries cannot be displayed. > This applies to MX80 10.4R3.4, and MX240(DPC) 10.2R1.8. > > This applies to both > set bridge-domains b101 routing-interface irb.96 and set routing-instances > e101 > instance-type vpls set routing-instances e101 routing-interface irb.101 > > Is this something that has been previously observed by anyone ? > Everything seems to be working just fine. > > > Kind regards, > Peter Krüpl > > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
