On Tue, 31 May 2011 23:18:34 +0300 Muhammad Adnan Mohsin <[email protected]> wrote:
> Hi Experts, > I have a MX240 router installed at a remote location. I am able to > telnet/SSH the router but when I run a command that needs to return a > large output (e.g. show log messages or show conf) the session hangs > and then I have to re-establish the connection. Because of this I > couldn't provide some outputs that were required by JTAC. As long as > the commands I give on the router don't have to return a large output, > the session remains intact. The current code that I am running is > 10.2R3.10. JTAC has recommended me to install 10.3R2 but I have a > feeling that won't work. Has somebody experience a similar issue? I > would appreciate if somebody could give me some guidance to > troubleshoot this problem. Sounds like your mtu value. -- Burkhard Ott System Administrator Revenuewire Inc. 1205 - 4464 Markham Street Victoria, BC V8Z 7X8 250-984-1132 ext. 7132 _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
