Thanks for the replies. I do not have any CoS configuration on my router. There is no Spanning-Tree is running between my device and customer device. I have no idea what is causing an increment in the network-control queue.
Any ideas would be appreciated. Thanks and regards, Gokhan On Thu, Jan 26, 2012 at 4:52 PM, Keegan Holley <[email protected]>wrote: > Well NC (network control) is a completely different queue than EF > (expedited forwarding). This could be normal. Several things such as > routing protocol updates are set to NC by default because it is > network control traffic or part of the network control plane. Such > traffic should be prioritized during congestion to keep the paths > stable. I wouldn't use the NC queue for other traffic if you can > avoid it and I wouldn't make this traffic best effort without figuring > out what it is. Is it possible that it's just a control protocol? I > know most routing protocols mark their hello's as NC. Spanning tree > BPDU's might do the same but I can't remember off the top of my head. > > > 2012/1/26 Gökhan Gümüş <[email protected]>: > > Dear Saku, > > > > Thanks for the reply. > > > > I checked the queues on the interface as seen below; > > > > LON> show class-of-service interface ge-2/0/4 > > Physical interface: ge-2/0/4, Index: 158 > > Queues supported: 8, Queues in use: 4 > > Scheduler map: <default>, Index: 2 > > > > Logical interface: ge-2/0/4.0, Index: 216 > > > > How can i use %100 BE by changing my config in Juniper? > > > > Thanks and regards, > > Gokhan > > _______________________________________________ > > juniper-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/juniper-nsp > > > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
