You can also run the following command on the backup RE to check it's state:
me@BLAH-re1> show system switchover Graceful switchover: On Configuration database: Ready Kernel database: Ready Peer state: Steady State If this command and "show task replication" on the master RE don't show the correct outputs, I agree with the recommendation to turn GRES/NSR on/off. If that doesn't work, reboot REs. Serge ________________________________ From: Mohammad <[email protected]> To: [email protected] Sent: Wednesday, February 15, 2012 6:44:42 AM Subject: Re: [j-nsp] MX960 Redundant RE problem Kindly find the following output, I hope it is helpful xxxxx> show task replication Stateful Replication: Enabled RE mode: Master Protocol Synchronization Status OSPF Complete BGP Complete IS-IS Complete MPLS Complete RSVP Complete {master} xxxx> _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
