Hi, has anyone ever tried using bulk configured interfaces with ICR (inter chassis redundancy) in JunosE.
The bulk config and the ICR config bits alone seem to work, but once its put together, it breaks: the PPPoE session is terminated before it gets to authenticate the user. 'show vlan subinterface' shows the dynamically created interface on the router which is in ICR master state. Here's the relevant bits from the config of one of the ERX: profile "vlan-pppoe" vlan auto-configure pppoe svlan ethertype 8100 vlan profile pppoe pppoeGoetel ! [...] interface gigabitEthernet 1/1 mtu 1522 encapsulation vlan auto-configure vlan vlan bulk-config "bulk-pppoe" profile vlan bulk-config "bulk-pppoe" "vlan-pppoe" vlan bulk-config "bulk-pppoe" vlan-range 80 89 ! interface gigabitEthernet 1/1.23 vlan id 23 icr-control-interface ip address 10.1.0.10 255.255.255.248 ip vrrp 23 virtual-address 10.1.0.9 no ip vrrp 23 preempt ip vrrp 23 priority 200 ip vrrp 23 enable ip vrrp 23 icr-partition icrVlan ip vrrp 23 icr-partition group vlan ip vrrp 23 icr-partition vlan-range 80 89 advertise-mac control-interface ! This is an ERX-310 with JUNOSe 11.3.2. The other ERX in the ICR pair is configured accordingly. When I disable the dynamic interface creation on the backup router with "no auto-configure vlan", the PPPoE client connects just fine. On the other hand, if I get rid of the "vlan bulk-config" and statically configure the PPPoE VLAN interfaces, it also works as expected. What am I missing? Regards, Martin _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
