Hi, I have an MX-80 acting as a PE router, where ge-1/1/1 is the CE-facing interface which is connected to the trunk port of a switch. The configuration looks like this:
[edit interfaces ge-1/1/1] flexible-vlan-tagging; encapsulation vlan-ccc; unit 0 { encapsulation vlan-ccc; vlan-id-range 700-800; family ccc; } [edit protocols] connections remote-interface-switch VLAN700-800 interface ge-1/1/1.0 connections remote-interface-switch VLAN700-800 transmit-lsp LSP_MX connections remote-interface-switch VLAN700-800 receive-lsp LSP_EX VLAN range 700-800 is being transported across MPLS to the remote PE device. The same interface, ge-1/1/1 is also receiving VLAN400 (through the trunk) but should not be sent via MPLS but to another switch connected to the MX-80. I tried the following configuration on the same interface: [edit interfaces ge-1/1/1] unit 400 { family bridge { interface-mode trunk; vlan-id-list 400; 'unit 400' Link encapsulation type is not valid for device type error: configuration check-out failed Any suggestions how to make this work? The same physical interface should be able to send specific VLANs out over MPLS and others out any other interfaces. Regards. *Saba Sumsam* *Network Engineer - Level 2* eintellego Pty Ltd s...@eintellego.net <a...@eintellego.net> ; www.eintellego.net Phone: 1300 753 383 ; Fax: (+612) 8572 9954 Cell +61 (0)424753773 facebook.com/eintellego PO Box 7726, Baulkham Hills, NSW 1755 Australia The Experts Who The Experts Call Juniper - Cisco – Brocade - IBM _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp