On Tue, Sep 18, 2012 at 11:24:04PM +0200, Nicolaj Kamensek wrote: > Am 18.09.2012 20:57, schrieb Chuck Anderson: > > Hi, > > >That is not true in my experience. L2 MAC Learning takes effect > >immediately upon seeing traffic enter the new MX port. The ARP entry > >will point to the new L2 next-hop immediately. > > interesting because we just had a server being relocated to a > different switch on a differekt xe port on the mx and after clearing > the arp cache for the specific irb interface, the host was up > immediately. We are running 11.4R2.14 and a > > show arp > > actually shows the xe interface instead of the irb interfaces as one > would expect.
It may be that if the server or client host is "quiet" and not sending anything that MAC learning will not occur right away. In that case the traffic will be sent to the old port until the MAC table entry ages out. By clearing the ARP, you cause the router to send an ARP broadcast to all ports (because something is probably trying to reach the server still), which triggers the otherwise quiet server/client to respond, causing the MX to learn the new L2 port where the MAC address now lives. This is a generic problem with Ethernet MAC learning, not something specific to the MX. If you keep a pinging going FROM the server to the default gateway for example, it should pick up the L2 move fairly quickly. _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
