Hi, After reading your comments, I will try to explain better what I'm trying to achieve. I'm trying to do classification and queueing on an ingress interface.
When the wan interface gets rate limit threshold (500mbits), all the traffic that is destinated to the high priority destination subnet gets precedence and no packet loss or lower packet loss, than the low priority. The egress traffic to these subnets goes to two different physical interfaces ( ge-1/0/5 and ge-1/0/5) So , from what I read from you, the ingress interface should "see" the rate limit of 500mbits gets congestion and then discard packets from wan that have destination (address) subnet that differs from the high priority subnet. For instance: If the current wan ingress traffic total is 450mbits and high priority traffic is 100mbits, and low priority is 350mbits = no packet discard, but if traffic towards high priority subnet is 300mbits and low priority is 300mbits, then the queuing / scheduler will drop the low priority traffic until the sources traffic gets shaped to 200mbits for the low priority and the high priority gets 300mbits. On Linux it's quite simple to achieve. Gustavo Santos Analista de Redes CCNA , MTCNA , MTCRE, MTCINE, JUNCIA-ER 2012/10/15 Doug Hanks <[email protected]> > >If you're having a hard time writing > >the proper code-points to a packet, I would assume the packets are > >classified correctly. > > s/correctly/incorrectly/ > > > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
