We need a lot more information to provide any useful answer. Please share the relevant config of the three routers and switch.
What IPv6 multicast group address are you using? Please share the output of the following commands from each of the three routers: show pim join extensive show pim rps extensive show multicast route extensive show route <source ip> extensive show mld group detail --Stacy On Nov 24, 2012, at 3:16 PM, Giuliano Cardozo Medalha <[email protected]> wrote: > people > > we did a setup lab for ipv6 multicast routing using juniper srx210 boxea and > 12.1R4 release > > 3 routers connected by a switch (ex2200) - star topology > > basically we did the configurarion with mld and pim using static rp > configuration using loopback of one of the routers > > the unicast routes were dynamic learning using is-is > > after create a streaming using vlc in one of the lan interface of router a > other clients could not be able to join the multicast v6 group using the same > software > > is there some special config to be able to do it work fine ? > > the ssm mode must be a better config ? > > using ipv4 it works ok > > if we connect one host directly to another it is possible to join the group > and see multicast streaming > > does anyone has some similar config that works on this kind of environment ? > > thanks a lot > > giuliano _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
