On Sat, May 25, 2013 at 12:29:12PM +0100, Phil Mayers wrote: > On 25/05/2013 12:01, Maciej Jan Broniarz wrote:
Hello, > >I am trying to do an initial setup on an SRX1400 but i get the following > >error: > > > >root# commit > >[edit groups junos-defaults] > > 'interfaces' > > Error accessing interface container object, may not be defined > >LIBJNX_SNMP_ENGINE_SCAN_FAILURE: snmp_engine_read: fscanf : > >/var/db/snmp_engine.db scanning: full_engine_id Error: Unknown error: 0 > >[edit groups junos-defaults] > > 'interfaces' > > cannot get intferface name. > >error: configuration check-out failed > > > >[edit] > > > >How should I fix it? > > We saw this recently on SRX3600, but I can't remember what the > solution was; if I recall correctly, there is some mandatory minimum > config that the setup guide omits, but I can't quite remember what > it was... > > What does "show interfaces" in "configure" mode look like before you > try to commit? It shows nothing :( mjb _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
