Branch SRX works fine, however (and I haven't looked at this in detail enough), "show interfaces diagnostics optics" on SRX650 with 3rd party optics isn't very reliable. I've had two cases where an optic that read -12db rx on an EX port, moved 1m to the SRX (same fibre patch, no bends and no change at the other end) suddenly showed -27db. Another optic shows -18db rx over a 5km link, where testing with a power meter says it's a 3db loss.
On 27 June 2013 06:47, Paul Stewart <[email protected]> wrote: > We've used "third party" optics with MX, M, EX, SRX, and J with no > issuesŠ. The closest issue I've come across was some 1000BaseT optics that > didn't fit properly (the optic was slightly narrower than the opening > leaving too much "wiggle room") but they will workedŠ > > The optics we have been using are "Prolabs" > > Cheers, > > Paul > > > On 2013-06-26 1:25 PM, "Robert Hass" <[email protected]> wrote: > > >Hi > >I have only experience with MX platfrom where I can use third party optics > >without any issues. > > > >We're going to buy also some SRX and EX gear. Are EX/SRX accept third > >party > >optics without any issues or we need any special coding ? > > > >Rob > >_______________________________________________ > >juniper-nsp mailing list [email protected] > >https://puck.nether.net/mailman/listinfo/juniper-nsp > > > > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
