Hi Robert,
What you have below only adds the interface to the OIL for that group. No IGMP
joins are generated!
Regards,
Vladislav A. VASILEV
On 10 Sep 2013, at 07:51, Robert Hass wrote:
> Hi
> I would like to setup static IGMP joins between Cisco and Juniper.
> But it's not working. Juniper is not sending IGMP Joins.
> Same configuration Cisco + Cisco working without issues. Any clues ?
>
> Interface configuration for Juniper at Cisco side:
>
> interface GigabitEthernet1/1/1
> description Juniper
> no switchport
> ip address 10.10.10.21 255.255.255.252
> ip pim passive
> !
>
> Here is output of IGMP membership - none :(
>
> cisco#sh ip igmp membership | include GigabitEthernet1/1/1
> cisco#
>
> Here is JunOS configuration:
>
> interfaces {
> ge-0/0/0 {
> unit 0 {
> family inet {
> address 10.10.10.22/30;
> }
> }
> }
> routing-options {
> static {
> route 0.0.0.0/0 next-hop 10.10.10.21;
> }
> }
> protocols {
> igmp {
> interface ge-0/0/0.0 {
> version 2;
> static {
> group 231.0.0.3;
> group 231.0.0.4;
> }
> }
> }
> pim {
> rp {
> static {
> address 10.10.10.255 {
> version 2;
> }
> }
> }
> interface ge-0/0/0.0 {
> mode sparse;
> version 2;
> }
> join-load-balance;
> }
> }
>
> Rob
> _______________________________________________
> juniper-nsp mailing list [email protected]
> https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
