A small topology diagram would help so we could figure out exactly what this interface points to. Not sure if its in the path or not. If it is, then the below comments already state what the problem is.
Thanks Darren http://www.mellowd.co.uk/ccie > Date: Wed, 27 Aug 2014 17:52:02 -0700 > From: [email protected] > To: [email protected] > Subject: Re: [j-nsp] rpm / ip-monitoring > > Instead of disabling the interface, can you just alter routing to avoid > that path, but RPM could still test since that interface would still be up? > > -Mike Gonnason > > > On Wed, Aug 27, 2014 at 5:37 PM, Tyler Christiansen <[email protected]> wrote: > > > Good point. I glossed over that a bit. > > > > In that case, you won't even be able to test if it's working or not as you > > have disabled it (as Andrew points out). I suppose you could write a > > script that re-enables the interface every hour or twenty four hours or > > whatever interval, then the RPM probe would just shut it back down if it's > > not fixing, but that seems a bit of a hassle. > > > > --tc > > > > > > On Wed, Aug 27, 2014 at 4:35 PM, Andrew Jones <[email protected]> wrote: > > > > > Surely the test will never recover without intervention, as the interface > > > it uses gets disabled? > > > > > > > > > On 28.08.2014 02:28, Tyler Christiansen wrote: > > > > > >> I could be mistaken, but I believe it automatically reverts when the > > test > > >> is successful unless you specify no-preempt. > > >> > > >> > > >> On Wed, Aug 27, 2014 at 12:50 AM, Mattias Gyllenvarg < > > >> [email protected]> > > >> wrote: > > >> > > >> Dear List > > >>> > > >>> I have a rpm /ip-monitor setup that is supposed to test the function > > of a > > >>> local internet line (ping internet destination). > > >>> > > >>> And disable it if it is not responding. > > >>> > > >>> This works fine BUT, how do I get it to re-enable when it is working > > >>> again. > > >>> > > >>> I need this to work with DHCP so I cannot work with a default route. > > >>> > > >>> > > >>> ********************** > > >>> > > >>> services { > > >>> rpm { > > >>> probe Internet { > > >>> test PING-GOOGLE-DNS { > > >>> target address 8.8.8.8; > > >>> probe-count 5; > > >>> probe-interval 2; > > >>> test-interval 20; > > >>> thresholds { > > >>> total-loss 4; > > >>> } > > >>> destination-interface fe-0/0/3.0; > > >>> } > > >>> } > > >>> } > > >>> ip-monitoring { > > >>> policy Local-Internet-Test { > > >>> match { > > >>> rpm-probe Internet; > > >>> } > > >>> then { > > >>> interface fe-0/0/3 { > > >>> disable; > > >>> } > > >>> } > > >>> } > > >>> } > > >>> } > > >>> > > >>> ************************* > > >>> > > >>> -- > > >>> *Med Vänliga Hälsningar / Best Regards* > > >>> *Mattias Gyllenvarg* > > >>> _______________________________________________ > > >>> juniper-nsp mailing list [email protected] > > >>> https://puck.nether.net/mailman/listinfo/juniper-nsp > > >>> > > >> _______________________________________________ > > >> juniper-nsp mailing list [email protected] > > >> https://puck.nether.net/mailman/listinfo/juniper-nsp > > >> > > > > > > _______________________________________________ > > > juniper-nsp mailing list [email protected] > > > https://puck.nether.net/mailman/listinfo/juniper-nsp > > > > > > > > > > > -- > > > > *Tyler Christiansen | Technical Operations* > > tyler <http://adap.tv/>@adap.tv <http://adap.tv/> | www.adap.tv > > *m :* 864.346.4095 > > _______________________________________________ > > juniper-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/juniper-nsp > > > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
