Figured something out. ge-1/0/0-47 had no config under them. Then again, neither did ge-0/0/0-47
As soon as I put some config under ge-1/0/47 (like family ethernet-switching) - that particular interface now showed up in the show command. ALL ge-0/0/* interfaces show up always though. Putting just 'disable' under all interfaces on both switches shows ge-0/0/* interface in show commands but not ge-1/0/* Thanks Darren http://www.mellowd.co.uk/ccie > From: [email protected] > To: [email protected] > Date: Fri, 5 Sep 2014 15:53:56 +0100 > Subject: [j-nsp] Juniper VC not showing all ports in show commands > > I was testing some Juniper VCs today and seeing some odd stuff. I have a two > member stack. In a show interfaces I can see all interfaces. When I try and > view certain protocol states on interfaces I can only see the VC master > interfaces. > > As an example if I do a show dot1x interfaces, I can only see ge-0/0/0 to > ge-0/0/47. Same with show spanning-tree interface. If I type show dot1x > interface ge-1/0/0 it show nothing at all. > > This is on a 4200 stack trying code 12.3R6.6 and 13.2+ > > > Looked at a very old stack we have running 10.3R3 and it shows all > interfaces, not only the master interfaces. > > Anyone else seen this? > > Thanks > Darren > http://www.mellowd.co.uk/ccie > > > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
