Hi Matthew-
This configuration should get you the desired result.
ge-0/0/4 {
description XXXX;
vlan-tagging;
unit 0 {
vlan-id 0;
family inet {
address 10.10.10.1/30;
}
}
unit 4055 {
vlan-id 4055;
family inet {
address 20.20.20.21/30;
}
}
}
- Damien
On Wed, Dec 3, 2014 at 9:01 AM, Matthew Crocker <[email protected]>
wrote:
>
>
> I have an EX4200 with the current interface:
>
> ge-0/0/4 {
> description "XXXXXX";
> enable;
> unit 0 {
> family inet {
> address A.B.C.D/30;
> }
> }
>
>
> I need to reconfigure it to support a VLAN
>
> ge-0/0/4 {
> description "XXXXXXXXXX";
> enable;
> unit 0 {
> family inet {
> address A.B.C.D/30;
> }
> unit 4055
> vlan-id 4055
> family inet {
> address X.Y.Z.W/30;
> }
> }
>
> i.e Unit 0 stays the same, untagged frames on go to that interface IP
> address. VLAN 4055 is new, tagged frames go to unit 4055
>
> Is it as simple as adding vlan-tagging to ge-0/0/4 and set unit 0 to
> vlan-id 0 ?
>
>
> --
> Matthew S. Crocker
> President
> Crocker Communications, Inc.
> PO BOX 710
> Greenfield, MA 01302-0710
>
> E: [email protected]
> P: (413) 746-2760
> F: (413) 746-3704
> W: http://www.crocker.com
>
>
>
>
>
> _______________________________________________
> juniper-nsp mailing list [email protected]
> https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
