you can try enabling labeled-unicast address family for family inet under bgp and advertise the loopbacks over that session. so the transport label will be signalled using BGP , then you can do a targeted LDP session between the loobacks of both PEs and then configure L2ciruit to exchange the VC labels .
i have set up something similar in the lab(except that it is inter-as l2circuit but the principle is the same) and it works fine . hope this helps. On Thu, Feb 19, 2015 at 11:53 AM, Mark Tinka <[email protected]> wrote: > > > On 19/Feb/15 11:51, Adam Vitkovsky wrote: >> Hi Scott, >> >> There are two ways how you can setup the E-lines using BGP. >> BGP Auto Discovery with LDP signalling. >> BGP Auto Discovery with BGP signalling. >> >> I think the second one is what you want to accomplish. > > I might have misunderstood the OP's question, but wasn't he asking about > how he can provision Martini EoMPLS circuits where FEC's are generated > from iBGP routes? > > Mark. > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
