Shut off defective member and remove itWith the replacement still powered off connect one VCP port to the VC stackPower on the replacement and confirm it is showing up properlyCable the other VCP into the VS stack A more detailed explanation is given here: http://www.juniper.net/techpubs/en_US/junos13.2/information-products/pathway-pages/ex-series/virtual-chassis-4300-x51.pdf
Jonathan> From: [email protected] > To: [email protected] > Date: Tue, 7 Apr 2015 16:32:01 +0000 > Subject: [j-nsp] Replacing a member of a virtual chassis? > > Good afternoon, > > I have an EX4300 stack consisting of 6 members connected together using the > cables on the back in to a single chassis. I have VC-Ports flapping on > member 3 which is leading me to believe I have a bad member on a hardware > level. I have looked for a procedure to remove the member from service and > install a spare and haven’t found one through Google. I’ve opened a TAC case > and am told I’ll receive the instructions but I’m wondering if anyone has > done this and has a pointer to the KB article or a simple set of steps to > complete. The Virtual chassis is not pre provisioned so I don’t have any > static mappings of serial numbers to mappings. Any pointers would be most > appreciated. Do I simply install the new member and it auto configures as > member 3 or are there request commands and the like I should issue first? > Any KB articles or general advise would be greatly appreciated. > > Thank you > Scott > > > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
