request chassis routing-engine power-off other-routing-engine etc..etc..? (....something along those lines)
I recall I just did this last week on an MX480 (someone put the same fxp0 IPs on both REs..) so I shut one RE down from the other RE with some type of 'power off' command to avoid ip-to-mac flipping every few seconds while I fixed it. Not a "reboot" command, but an actual "hey chasissd -- kill the power to this thing" command. Steinar's command re: kill all power to CB0 should do the same thing, but takes down the fabric board as well. - Ck. On 19/08/2015, at 6:42 PM, Tom Eichhorn <[email protected]> wrote: > Hi, > > I was just wondering, is there a way to force reset a routing engine > from the other in the same chassis? _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
