Hi Graham, These are 3rd party. I was told that by my SE that the platform fully supports 3rd party optics... not that that really means anything :)
> On Jul 18, 2016, at 4:38 PM, Graham Brown <[email protected]> > wrote: > > Hi Jason, > > Are these SFPs Juniper supplied or third party? Over the years there have > been many documented issues with Base-T SFPs, where you lose physical and > they report as being up. > > IIRC, the Juniper supplied SFPs are ok and I have tested third party ones > that do work, but it's a little hit and miss. > > NB: I have not tested the EX9200. > > HTH, > Graham > > Graham Brown > Twitter - @mountainrescuer > LinkedIn > > On 19 July 2016 at 08:04, Jason Lixfeld <[email protected]> wrote: > Hey there, > > I’m messing around with a lab EX9204 with a EX9200-40x1G-SFP running 14.2R4.9 > > I’ve got two ports (on the same box) connected together with 10/100/1000T > SFPs in each. > > [email protected]# show interfaces | display set > set interfaces ge-0/1/0 unit 0 > set interfaces ge-0/3/0 unit 0 > > [email protected]# run show lldp neighbors > Local Interface Parent Interface Chassis Id Port info > System Name > ge-0/1/0 - 30:7c:5e:96:ac:80 ge-0/3/0 > lab01.juniper > ge-0/3/0 - 30:7c:5e:96:ac:80 ge-0/1/0 > lab01.juniper > > [edit] > [email protected]# > > I’m noticing that if I disable either interface, it’s partner interface does > not go down. I’m not talking about Ethernet OAM, just simple layer 1 link > detection with copper SFPs. In my past experiences with various Cisco > platforms, this works with no special configuration required. One thing of > interest is that the box thinks the media type is Fiber. > > [email protected]# set interfaces ge-0/1/0 disable > > [edit] > [email protected]# commit > commit complete > > [edit] > [email protected]# Jul 18 15:56:42.333 2016 lab01.juniper mib2d[2006]: > %DAEMON-4-SNMP_TRAP_LINK_DOWN: ifIndex 558, ifAdminStatus down(2), > ifOperStatus down(2), ifName ge-0/1/0 > > > [edit] > [email protected]# run show interfaces ge-0/1/0 > Physical interface: ge-0/1/0, Administratively down, Physical link is Down > Interface index: 149, SNMP ifIndex: 558 > Link-level type: Ethernet, MTU: 1514, MRU: 0, LAN-PHY mode, Speed: > 1000mbps, BPDU Error: None, MAC-REWRITE Error: None, Loopback: Disabled, > Source filtering: Disabled, > Flow control: Enabled, Auto-negotiation: Enabled, Remote fault: Online, > Media type: Fiber > Device flags : Present Running Down > Interface flags: Hardware-Down Down SNMP-Traps Internal: 0x4000 > Link flags : None > CoS queues : 8 supported, 8 maximum usable queues > Current address: 30:7c:5e:96:a5:65, Hardware address: 30:7c:5e:96:a5:65 > Last flapped : 2016-07-18 15:56:42 EDT (00:00:11 ago) > Input rate : 0 bps (0 pps) > Output rate : 0 bps (0 pps) > Active alarms : LINK > Active defects : LINK > Interface transmit statistics: Disabled > > Logical interface ge-0/1/0.0 (Index 345) (SNMP ifIndex 570) > Flags: Device-Down SNMP-Traps 0x4004000 Encapsulation: ENET2 > Input packets : 3 > Output packets: 4 > Protocol multiservice, MTU: Unlimited > > [edit] > [email protected]# run show interfaces ge-0/3/0 > Physical interface: ge-0/3/0, Enabled, Physical link is Up > Interface index: 169, SNMP ifIndex: 526 > Link-level type: Ethernet, MTU: 1514, MRU: 0, LAN-PHY mode, Speed: > 1000mbps, BPDU Error: None, MAC-REWRITE Error: None, Loopback: Disabled, > Source filtering: Disabled, > Flow control: Enabled, Auto-negotiation: Enabled, Remote fault: Online, > Media type: Fiber > Device flags : Present Running > Interface flags: SNMP-Traps Internal: 0x4000 > Link flags : None > CoS queues : 8 supported, 8 maximum usable queues > Current address: 30:7c:5e:96:a6:af, Hardware address: 30:7c:5e:96:a6:af > Last flapped : 2016-07-18 14:52:35 EDT (01:04:23 ago) > Input rate : 0 bps (0 pps) > Output rate : 0 bps (0 pps) > Active alarms : None > Active defects : None > Interface transmit statistics: Disabled > > Logical interface ge-0/3/0.0 (Index 348) (SNMP ifIndex 544) > Flags: Up SNMP-Traps 0x4004000 Encapsulation: ENET2 > Input packets : 4 > Output packets: 4 > Protocol multiservice, MTU: Unlimited > > [edit] > [email protected]# > > Am I missing something somewhere? > > Thanks in advance. > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
