Alex,
Great info.Please advise where we can find these config file, Under VM ?
Please guide.
Aqeel Ahmad.
On Thursday, November 17, 2016 8:37 PM, Alexander Marhold
<[email protected]> wrote:
Hi Yes !
By changing parameters in the boot/loader.conf you can change certain
behavior
vm_chassis_i2cid="21" for MX960, "33" for MX480, and "48" for MX240
vm_ore_present=“0” for a single RE; vm_ore_present=“1” for dual REs
vm_instance=“0” for the the RE, the first FPC slot; vm_instance=“1” for
second FPC
slot, and so on (not applicable to RE)
Let’s say, you want to run 1 RE and 1 FPC on slot 0 (you can run 2 REs and
up to 12 FPCs if
you emulate an MX960)
However the real imitation is somewhere else namely that VMware only allow
up to 10 interfaces on one VM
I think that currently this is not officially supported but as far as I know
Juniper plans to allow up to 2 REs and up to ?(3 and more) separate PFE
instances
With best regards
alexander
-----Ursprüngliche Nachricht-----
Von: juniper-nsp [mailto:[email protected]] Im Auftrag von
Stefan Stoyanov
Gesendet: Donnerstag, 17. November 2016 15:12
An: [email protected]
Betreff: [j-nsp] vMX
Hello everyone,
Is there someone who is familiar with vMX?
I have installed vMX under VMWARE and I wanted to know if it's possible to
add more than one FPC.
I could find any documentation about that.
Thanks.
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
