I do believe that it is not until you stop the capture that all data is
flushed to the capture-file. If you have a small enough flow, the file
will be empty until you stop the capture.
/Per
On 17 Feb 2017, at 17:44, Jonathan Call wrote:
I followed the instructions listed here to create and start a capture
for a single destination IP address on an SRX5400 in a lab:
https://kb.juniper.net/InfoCenter/index?page=content&id=KB21563
I can see a flow for the IP when I run a "show security flow session
destination-prefix 172.16.x.x/32" but no traffic is captured. The file
size remains at zero.
I'm new to this platform so any suggestions would be appreciated.
Jonathan
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
